MIMAKI JFX-1631/1615 - Adjusting UV Light Level

Checking UV ink curing level
4-37
4
Maintenance
11
Press the key.
• Test drawing starts.
12
Check the drawing pattern after completion of the drawing.
• If the UV light intensity goes lower, good drawing pattern cannot be obtained. In this case execute the
operation of “Adjusting UV light level”.
Adjusting UV light level
1
Select the “UV LEVEL MODE” of the set up menu.
(1)Press the key in the local mode.
(2)Select the [SET UP] by pressing the or key, and press the key.
(3)Select the [UV LEVEL] by pressing the or key
(4)Press the key.
2
Select a light level by pressing the or keys.
• Setting value : Strong, Weak, Standard, No, No Draw
(Light intensity becomes stronger)
3
Press the key.
4
Press the key several times to end the setting.
5
Check UV curing again
• Set media and create the drawing pattern of the UV light intensity. ( P.4-36)
• When the head or the water heating device has not reached the predetermined temperature on step 9, a
message is displayed. Drawing is not allowed in such cases. When the display is disappeared, drawing
can be started.
If the UV ink curing level is not changed by adjusting the UV light intensity, the UV LED is
deteriorated.
• Check the UV LED irradiation duration ( P.4-35)
** TEST DRAW **
ENTER
FUNCTION
ENTER
ENTER
SET UP
UV LEVEL : H I GH
SET UP
UV LEVEL <e n t >
ENTER
END