MIMAKI JFX-1631/1615 - Setting the light intensity of the UV LED

3-10
Setting the light intensity of the UV LED
The light intensity of the UV LED may be set in 3 stages.
This setting is made when the media vulnerable to the heat is used or when the test drawing is made in which the
lighting of the UV LEDs is not desired.
1
Press the key in the local
mode.
2
Select the [SET UP] by pressing the or key.
v
3
Press the key.
4
Select the [UV LEVEL] by pressing the or key.
5
Press the key.
6
Press or keys to select light intensity.
• Set values: HIGH , STANDARD , LOW , NONE , NOPRINT
7
Press the key.
8
Press the key several times to end the setting.
HIGH The UV LED is lit with 100% of its light intensity.
STANDARD The UV LED is lit with 75% of its light intensity.
LOW The UV LED is lit with 50% of its light intensity.
NONE The UV LED is not lit while drawing is being performed.
NOPRINT
The drawing is not performed and only the UV LED is lit. Use when drawing is performed without the UV
LED is lit etc., and when you wish to make it cure afterward. (Normally, this setting will not be made.)
• The light intensity of the UV LED may be set on the RIP side, when performing the remote drawing. For
details, please refer to the Instruction Manual of your RIP.
FUNCT I ON
VIEW <ENT>
FUNCTION
FUNCT I ON
SET UP <ENT>
SET UP
FEED COMP . <en t >
ENTER
SET UP
UV LEVEL <e n t >
SET UP
UV LEVEL : H I GH
ENTER
ENTER
END