4-2
Routine maintenance
Be sure to conduct maintenance works for the device depending on operation frequency or periodically so as to
use the device for a long time while keeping its drawing accuracy.
When the device is left unused for a long period of time
Recovery for when the device is left unused for a long period of time
Notes on cleaning
Maintenance of frame component
If the frame components of the device have stained, dampen a poece of soft cloth with water or neutral detergent
diluted with water, squeeze it and wipe the frame components clean.
• Be sure to turn off the main power switch on left side of the device. ( P.2-14)
• Remove the media being set.
If unused for 3 to 4 days (Using white ink)
Perform sub-tank maintenance.
If unused for about 1 week
Remove ink from the ink path.
If unused for about 2 weeks
Clean the ink path.
• Never disassemble the device. Disassembling the device can result in electric shock hazards and
breakage of the device.
• Prevent moisture from entering inside device. If the inner part of the device becomes wet, electric shock
hazards and breakage of the device can result.
• Conduct maintenance works after turning off the main power switch and detaching the power cable. If
not, unexpected troubles can arise.
• Make maintenance after the UV LED has been sufficiently cooled, or burn injury may occur.
• Do not use benzine, thinner or chemical agents containing abrasives. Such materials can deteriorate or
deform the surface of the cover.
• Do not apply lubricating oil or the like inside the device. Such materials can cause the printer mechanism
to fail.
To Next Page
Loading...
