MIMAKI JFX-1631/1615 - Move the Y-Bar

Drawing an image from source data
2-13
2
Basic Operations
Move the Y-bar
When you wish to check the drawing results etc., you can move the Y-bar.
Set the evacuation position (view position) of the Y-bar in advance.
Setting the view position
1
Press the key in the local mode.
2
Press the key.
3
Press the key.
4
Press the key.
5
Set the moving position by pressing the or
keys.
• If you press key, the Y-bar will move to the back of the table
centering the origin of the drawing.
• If you press key, the Y-bar will move to the front of the table
centering the origin of the drawing.
6
Press the key.
• The value is set, and the screen returns to Step 2.
Evacuation of Y-bar from the table
Used for evacuating the Y-bar from the table for checking a drawing result and so on.
1
Press the key in the local mode.
2
Press the key.
3
Press the key.
• The Y-bar moves.
FUNCT I ON
VIEW <ENT>
FUNCTION
VIEW
START <en t >
ENTER
VIEW
SET V I EW POS <en t >
VIEW
POS I T I ON : * * * * MM
ENTER
VIEW
POSI T ION : 500 MM
MOV I NG NOW
PLEASE WA I T
ENTER
FUNCT I ON
VIEW <ENT>
FUNCTION
VIEW
START <en t >
ENTER
MOV I NG NOW
PLEASE WA I T
ENTER