2-8
Execution of head cleaning
When a correct pattern is not obtained in the test drawing, perform the head-cleaning. As for the head cleaning,
the following 4 types are available.
When cleaning with “Normal” or “Hard” or “SUBTANK MAINTE”
1
Press the key in the local mode.
2
Select the cleaning type with or keys, press
the key.
3
Select the head and set execution/non-execution of
cleaning.
(1) Select the head with or keys.
(2) Select execution/non-execution of the head cleaning
with or keys.
• Select execution of cleaning for every head.
Execute Cleaning : A color of an ink cartridge being set is displayed.
Not Execute Cleaning : “ - ” is displayed
4
Press the key.
• Cleaning is started.
• When the cleaning is completed, a mode is returned to the local mode.
5
Execute test drawing and check the result of the test drawing.
• Repeat cleaning and test drawing until normal result is obtained.
normal
To be used if ten odd numbers of the lines are missing when the test pattern is made.
Suction and wiping will be performed.
P. 2- 8
wiping
To be used if several numbers of the lines are missing when the test pattern is made. Only the
wiping with the wiper will be performed.
P. 2- 9
hard To be used when the missing of the lines is not improved with the “Normal” cleaning.
P. 2- 8
SUBTANK
MAINTE
To solve the ink path error that occurred during drawing, perform [Sub tank maintenance]
cleaning.
P. 2- 8
power on To be used for cleaning automatically when turning the power on.
P.2-10
To Next Page
Loading...
