MIMAKI JFX-1631/1615 - CHAPTER 4 Maintenance

Items required for using this unit conveniently, such as an ink
replacing method or a cleaning manner, are described.
Routine maintenance ........................... 4-2
When the device is left unused for a long
period of time ............................................4-2
Notes on cleaning .....................................4-2
Maintenance of frame component ............ 4-2
Ink cartridge.......................................... 4-3
Replacing with a new ink pack .................4-3
State of Lamp ...........................................4-5
How to shake an ink cartridge .................. 4-6
Ink cartridge trouble ..................................4-7
Avoiding dripping of ink droplet
at printing.............................................. 4-8
Cleaning of the head guard plate ............. 4-8
Cleaning nozzle face automatically .. 4-10
Setting of Interval Wiping .......................4-10
Setting of Interval Cleaning ....................4-11
Cleaning of wiper................................ 4-12
Subtank Maintenance......................... 4-15
Prevent the nozzle clogging of
special color........................................ 4-16
When the waste ink is pooled up...... 4-17
Disposing of the ink in the waste
ink tank ...................................................4-17
Disposing of the ink in the wiper tank ..... 4-18
Regular maintenance for white ink... 4-19
Replacing the filter of the cooling
fan ........................................................ 4-21
Replacing the mist suction filter....... 4-23
If the dot position is misaligned........ 4-24
In case defective printing is not
resolved............................................... 4-26
Filling the ink ...........................................4-26
Replacing water in water heater
tank ...................................................... 4-28
Replacement method of antifreeze
liquid water .............................................4-29
Replacing the UV LED Unit filter....... 4-33
Irradiation Time of UV LED Unit........ 4-35
Displaying the irradiation time of
the UV LED unit ......................................4-35
Resetting the irradiation time of the
UV LED unit ............................................4-35
Checking UV ink curing level ............ 4-36
Adjusting UV light level ...........................4-37
Setting vacuuming / blowing level
of the vacuum unit.............................. 4-38
Drawing the Drop Pattern .................. 4-39
CHAPTER 4
Maintenance