MIMAKI JFX-1631/1615 - Interruption of Drawing

2-12
5
Taking out the media after completion of drawing
(1) Follow the "Evacuation of Y-bar from the table" ( P.2-13) to evacuate the Y-bar from the table.
(2) Press the key to turn the suction OFF.
(3) Press the key to turn the BLOW lamp on.
(4) Press the key to turn the blowing ON.
(5) Remove the media.
(6) Press the key to turn the blowing OFF.
Interruption of drawing
To interrupt the drawing, stop the drawing operation and erase the received data from the device.
1
Press the key while drawing.
• Drawing operation stops.
• When data is transmitted from the computer, the computer stops
transmission of data.
2
Press the key.
3
Press the key.
• Received data is erased and the device returns to the local mode.
• During printing, media may be heated by the UV LED and raised, causing drawing to be interrupted. In
this case, set new media and restart drawing.
ON/OFF
VACUUM/BLOW
ON/OFF
ON/OFF
*REMOTE*
2.5mm
REMOTE
DATA CLEAR
<ENT>
DATACLEAR
** DATA CLEAR **
ENTER