2-14
Turning the power OFF
To turn off, check first whether or not there is data received and there remains data that has not yet been output
in the device.
1
Turn the power of the connected computer off.
2
Press the power button to cut the power.
• Execute the cool down operation when UV LED is on.
• The power is cut automatically when the cool down operation is
completed.
Preventing nozzle drop out while power-off
Even while the power switch is off, the machine starts periodically and executes various functions to prevent
nozzle drop out. (Supported from the firmware ver.2.40)
1
When you start up the machine from the sleep mode,
the sleep operation is performed, and the power switch
is turned off automatically.
• The sleep operation is completed in about 30 min.
• After “POWER OFF PLEASE WAIT” was displayed, the power
switch is turned off automatically.
When turning the power OFF
Do not turn the main power switch OFF.
If the main power switch is ON, the power periodically turns on and the nozzle drop out prevention function
is operated.
If the main power switch is OFF, the sleep function does not work and this may cause nozzle drop out.
When this device is not used for a long time, execute the following:
(1) Press the power button to off the lamp.
(2) Confirm that the shutdown operation is completed.
(3) Turnoff the main power switch on the rear side of this device. ( P.1-3)
• Do not turn off the power switch at startup from the sleep mode. When the sleep operation has been
completed, the machine turns off the power switch automatically.
• Cleaning is not performed.
• Ink has not been consumed.
• Until two hours have passed after the power switch was turned off, the machine starts every 10 min.
When two hours or more have passed after the power switch was turned off, the machine starts every
one hour.
To Next Page
Loading...
