MIMAKI JFX-1631/1615 - Page 143

6-9
Function Flowchart
6
Appendix
1 to 9
HIGH , STANDRD , LOW,
NONE , NOPRINT
HOST, PLOT HOST, PLOT
MM, INCH
SET UP
I NK LAYERS : 1
SET UP
UV LEVEL : H I GH
SET UP
PR I NT MODE : HOST
SET UP
MM / I NC H : MM
SET UP
INK LAYERS :HOST
LEVEL 0 to LEVEL 3
SET UP
WA I T I NG < e n t >
SET UP
WA I T I NG : LEVEL1
LEVEL 0 to LEVEL 3
SET UP
DRAWI NG < e n t >
SET UP
DRAWI NG : LEVEL 1
SET UP
INITIALIZE OK? :ent
SET UP
UV SCAN ADD : 0
0 to 9
PRINT, REMOTE, NONE normal, 0 to 60 sec
SET UP
POST CURE : PR I NT
Pr int End
interval feed:normal
ON, OFF 1 to 50
POST CURE
af ter pr int :ON
POST CURE
COUNT : 1
1 to 3100 mm
POST CURE
Med I a LEN : 3100mm
When [DRAWING RANGE] is “Cure Print”
When [DRAWING RANGE] is “after print”
ON, OFF ON, OFF
SET UP
WO R K C H A N G E : O N
SET UP
VACCUM : ON
When [WORK CHANGE] is “ON”