MIMAKI JFX-1631/1615 - Page 70

3-26
6
Press the or key to select the feed interval
after drawing is completed.
NOMAL : Feed interval after drawing is completed is the same as
during drawing.
0 to 60 sec. : Feed operation is performed with the set interval. (If the set value is longer than the scan
operation interval, feed is performed with the scan operation interval.)
7
Press the key.
8
Press the key several times to end the setting.
When [DRAWING RANGE] is “after print”
Register the number of UV irradiations to be performed after drawing and the drawn image length.
1
Press the key in the local mode.
2
Select the [SET UP] by pressing the or key
and press the key.
3
Select the [POST CURE] by pressing the
or key and press the key.
• When [DRAWING RANGE] of the maintenance function is “after
print”, the right screen is displayed.
4
Select ON/OFF by pressing the or key and
press the key.
• If you select “OFF”, proceed to the Step 8.
5
Select the number of post cure irradiations (1 to 50) by
pressing the or key and press the
key.
6
Set the length of the image to be drawn by pressing the
or key.
• After ink curing, the Post Cure Unit becomes hot. Do not touch it after curing preferably.
• When you set the printing method other than “Panel Setting” in [Print Condition] - [UV mode] submenu
of RasterLinkPro5, the contents set here become invalid, and UV irradiation is performed with the
method set in RasterLinkPro5.
Pr i n t end
interval feed:NOMAL
ENTER
END
FUNCT I ON
VIEW <ENT>
FUNCTION
SET UP
FEED COMP . <en t >
ENTER
SET UP
af ter pr int OFF
ENTER
POST CURE
COUNT : 1
ENTER
POST CURE
COUNT : 3
ENTER
POST CURE
Me d i a LEN : 1