MIMAKI JFX-1631/1615 - Page 73

3-29
Use the Post Cure Unit
3
Useful Function
5
Press the key.
• The Y bar moves and UV irradiation with the post cure is performed.
• Here, irradiation from the post cure irradiation position at the front side up to 2700mm (for JFX-1615plus,
1100mm) is performed.
• If the image size registered in the Step 2 is 2700mm (for JFX-1615plus, 1100mm) and below, irradiation is
performed only on the registered area.
• If you do not perform UV irradiation with the post cure, enter the key.
• When irradiation with the post cure is completed, the screen on the
right is displayed.
6
Align the back edge of the image with the
post cure irradiation position (back
edge).
• The back edge of the post cure irradiation position
is the position of 2850mm (for JFX-1615plus,
1250mm) from the origin.
7
Press the key.
• Post cure irradiation is performed on the area of 500mm from the back edge of the image.
• When post cure irradiation is completed, the machine returns to the local mode.
• If the image size registered in the Step 2 is 2700mm (for JFX-1615plus, 1100mm) and below, even if you
press the key, post cure irradiation is not performed.
ENTER
END
mo v e me d i a f o r wa r d
OK ? : e n t
Origin
Post cure irradiation
position (back edge)
ENTER
ENTER