MIMAKI JFX-1631/1615 - Page 75

Use the Post Cure Unit
3-31
3
Useful Function
3
Press the key in the local mode.
4
Select the [POST CURE] by pressing the
or key.
5
Press the key.
6
By pressing the or key, determine the start
position of re-irradiating lamp light.
• Enter the distance from the front edge of the table to the start
position of irradiation.
• Set values : 0 to 2890mm (for JFX-1615plus, 0 to 1290mm.)
7
Press the key.
8
By pressing the or key, determine the end
position of re-irradiating lamp light.
• Enter the distance from the front edge of the table to the end position
of irradiation.
• Set this in consideration of the depth of the Post Cure Unit.
• Set values : 0 to 2890mm (for JFX-1615plus, 0 to 1290mm.)
9
Press the key.
• The setting screen of the number of irradiations is displayed.
10
By pressing the or key, set the number of
irradiations.
• Set values : 1 to 50 times
• By the set number of times, the Y bar goes and returns with irradiating lamp light.
11
Press the key twice.
• Re-irradiating UV lamp light starts by the Post Cure Unit.
• After the set number of irradiations is completed, the machine
returns to the local mode.
• When [DRAWING RANGE] of the maintenance function is set to “after print”, the setting
value differs.
for JFX-1631plus : 150 to 3040mm
for JFX-1615plus : 150 to 1440mm
• When [DRAWING RANGE] of the maintenance function is set to “after print”, the setting
value differs.
for JFX-1631plus : 150 to 3040mm
for JFX-1615plus : 150 to 1440mm
• After ink curing, the Post Cure Unit becomes hot. Do not touch it after curing preferably.
FUNCT I ON
VIEW <ENT>
FUNCTION
FUNCT I ON
POST CURE <ENT >
POST CURE
START POS : 0mm
ENTER
POST CURE
START POS : 100mm
POST CURE
END POS : 0mm
ENTER
POST CURE
END POS : 1000mm
POST CURE
COUNT : 2
ENTER
POST CURE
COUNT : 3
POST CURE
PLEASE WA I T
ENTER