Mindray BeneVision N1 User Manual

BeneVision N1 Patient Monitor Operator’s Manual D - 9
Loading Default Config
Failed
Low A The default configuration was not correctly
loaded. The monitor will restore to the factory
default configuration for the current patient
category.
Read dock E2PROM error! High C 1. Check if you’re using the specified external
display.
• If you’re using the specified external display,
remove the N1 from the Dock, and reconnect
the N1 and the Dock.
• If you’re not using the specified external
display, replace current external display with
the specified external display. Then remove
the N1 from the Dock, and reconnect the N1
and the Dock.
2. If the alarm persists, contact your service
personnel.
XX Conflicts
(XX refers to the module
label)
Prompt / The same type of corresponding module being
used exceeds the supported number. Remove
the conflict module.
XX Measurement has
been closed
(XX refers to the module
label)
Prompt / The parameter module is disabled. Switch on the
module if you want to use it. For more
information, see
3.11.1 Switching On or Off a
Parameter
.
The display setup for XX is
disabled.
(XX refers to the
parameter label)
Prompt / The parameter of the newly inserted module is
not displayed on the screen. Select a desired area
to display the parameter numerics and
waveforms. For more information, see
3.11.2 Displaying Parameter Numerics and
Waveforms
.
The patient data storage
space is nearly full. Please
delete some discharged
patients.
Med B The storage space of the monitor is full. Delete
unnecessary earlier discharged patient.
Alarm message Default priority
Indication on
alarm reset
Cause and solution

Mindray BeneVision N1 Specifications

General

Brand	Mindray
Model	BeneVision N1
Category	Medical Equipment
Language	English