13-1
13 Recording
13.1 Using a Recorder
The thermal recorder records patient information, parameters numerics (measured value
and manual input value), SpO
2
waveforms (if configured), and so on.
(1) Start/Stop key: press to start a recording or stop the current recording.
(2) Indicator
On: when the recorder works properly.
Off: when the monitor is switched off.
Flash: when an error occurred to the recorder, e.g. the recorder runs out of
paper.
(3) Paper outlet
(4) Recorder door
(5) Latch
13.2 Loading Paper
1. Press the latch at the upper right of the recorder door to open the door.
2. Insert a new roll into the compartment as shown below.
3. Close the recorder door.
4. Check if paper is loaded correctly and the paper end is feeding from the top.
(3)
(4)
(2)
(1)
(5)
To Next Page
Loading...
