Mindray VS-900 - 4 Patient Data Management; Admitting a Patient; Admitting a Patient by the Admit Patient Hardkey

4-1
4 Patient Data Management
4.1 Admitting a Patient
The monitor displays physiological data and stores them in the trends as soon as a patient
is connected. This allows you to monitor a patient that is not admitted yet. However, it is
recommended that you fully admit a patient so that you can clearly identify your patient,
on recordings, reports and networking devices.
NOTE
 If the monitor enters and then exits Standby mode during patient monitoring,
you must re-admit the patient for the monitoring.
4.1.1 Admitting a Patient by the Admit Patient Hardkey
1. Press the Admit Patient hardkey to access [Patient Demographics] menu.
2. Enter the demographic details.
If the monitor is connected to ADT database through Gateway, when you input
patient MRN, the patient information in the same MRN stored in ADT database will
automatically synchronize to patient demographics of the monitor.
3. Select [Ok] key.