Mindray VS-900 - Setting the CMS; Selecting a CMS; Clearing the Selected CMS at Startup; Certificates Maintenance

14-5
 Admit the monitor on the CMS. Refer to the Hypervisor VI Operator’s Manual
(PN: 300B-20-47610) for details of admitting a monitor.
 Setting the CMS (refer to section 14.4.1 Setting the CMS for details), and then
selecting a CMS (refer to section 14.4.2 Selecting a CMS for details).
14.4.1 Setting the CMS
You can configure up to 30 central stations (CMS) for your monitor. To set the CMSs,
1 Select [Main]→[Maintenance>>]→[User Settings >>]→enter the required
password→Select [Ok]→[Network>>].
2. Set [Select CMS] to [On].
3. Select [Central Station Setup >>].
4. Set CMS names and corresponding IP addresses.
14.4.2 Selecting a CMS
If [Select CMS] is enabled, you can select the CMS for the current monitoring.
To select the CMS, select the prompt message area at the bottom of the screen. Then the
selected CMS name will display.
If the CMS you select does not have a name, this area displays ‘‘???’’.
14.4.3 Clearing the Selected CMS at Startup
You can clear the selected CMS each time the monitor restarts after being powered off for
more than 2 minutes.
To clear the selected CMS,
1 Select [Main]→[Maintenance>>]→[User Settings >>]→enter the required
password→Select [Ok]→[Network>>].
2. Set [Clear CMS IP at startup] to [On]
The selected CMS will not be cleared when only one CMS is configured, or the monitor is
restarted within 2 minutes.
This function is switched off by default.
14.5 Certificates Maintenance
You can import or delete the monitor’s certificates.
1. Select [Main Menu]→[Maintenance>>]→[User Maintenance>>]→enter the
required password→[Network >>]→[Certificates Maintenance >>].