Mindray VS-900 - Understanding the NIBP Numerics; Setting NIBP; Setting Interval; Setting the Initial Cuff Inflation Pressure

9-6
9.6 Understanding the NIBP Numerics
The NIBP display shows numerics only as below. Your display may be configured to look
slightly different.
(1) Unit of pressure: mmHg or kPa
(2) Systolic pressure
(3) Diastolic pressure
(4) Mean pressure obtained after the measurement and cuff pressure obtained during
the measurement
(5) Time of last measurement
(6) Time remaining to next measurement
(7) Measurement mode
9.7 Setting NIBP
Select NIBP parameter area to access the [NIBP Setup] menu.
9.7.1 Setting Interval
In [NIBP Setup] menu, you can select [Interval] and set to:
 [Manual]: NIBP measurement is started manually.
 [1 min], [2 min], [2.5 min], [3 min], [5 min], [10 min], [15 min], [20 min], [30 min],
[
1 h], [1.5 h], [2 h]: The monitor automatically measures NIBP based on the
specified time interval.
 [Program 1] and [Program 2]: The monitor automatically measures NIBP based
on a program configured by user.
9.7.2 Setting the Initial Cuff Inflation Pressure
You can set the initial cuff inflation pressure manually. In the [NIBP Setup] menu, select
[Initial Pressure] and then select the appropriate setting.
The initial inflation pressure range is as follows:
(2)
5
6
(1)
(4)
7
(3)
(5) (6)
(7)