9-7
Patient Category Range (mmHg) Default (mmHg)
Adult 80 - 280 160
Pediatric 80 - 210 140
Neonate 60 - 140 90
NOTE
For known hypertensive patients, you need to set initial cuff pressure to a
higher value to reduce the measurement time.
9.7.3 Setting NIBP End Tone
The monitor can issue a reminder tone at the completion of NIBP measurement. The NIBP
End Tone is off by default. You can switch it on by accessing the [NIBP Setup] menu.
9.7.4 Switching On/Off Measurement on Clock
In auto measuring mode, if the clock is enabled, the NIBP automatic measurement
interval will be synchronized with the real time clock.
For example, if [Clock] is set to [On], and [Interval] is set to [20min], and then you start an
NIBP auto measurement at 14: 03, the next measurement will be taken at 14: 20, and the
following measurement time will be 14:40, 15:00 and so on.
9.7.5 Configuring a Custom Program
In [NIBP Setup] menu, you can select [Custom Program>>] and configure the duration
of automatic measurement cycle, and the time interval between two NIBP measurement.
You can define two programs, respectively program 1 and program 2. Each program can
at most include five cycles: A, B, C, D, and E. In each cycle, the [Duration] and [Interval]
can be set individually.
You shall start the programmed NIBP measurement manually, and then the monitor will
automatically perform the measurement based on the cycle and interval you have
defined.
To Next Page
Loading...
