Mindray VS-900 - Setting up a Monitor; Changing Language; Configuring the Timeout of Clinician ID; Showing;Hiding Patient Name

3-7
3.5.1 Setting up a Monitor
To install a monitor or change the monitor’s location, you need to set it as follows:
1. Select [Main]→ [Maintenance >>]→[User Settings >>]→ Enter the required
password→ Select [Ok] and then access [User Settings] menu.
2. Set up [Monitor Name], [Department] and [Bed No.].
You can set [Changing Bed No.] to:
 [Unprotected]: enables you to change Bed No. from the [Patient Demographics]
menu.
 [Protected]: prevents you from changing Bed No. from the [Patient
Demographics
] menu.
3.5.2 Changing Language
1. Select [Main]→[Maintenance >>]→[User Settings >>]→Enter the required
password Select [Ok] to access [User Settings] menu.
2. Select [Language] and then select the desired language.
3. Restart the monitor.
3.5.3 Configuring the Timeout of Clinician ID
You can configure the retention time of a clinician ID each time it is entered.
1. Select [Main]→[Maintenance >>]→[User Settings >>]→Enter the required
password→Select [Ok]and then access [User Settings] menu.
2. Select [Clinician ID Time out] and then set the time.
3.5.4 Showing/Hiding Patient Name
You can show or hide the current patient name in the main screen. To do so, follow this
procedure:
1. Select [Main]→[Maintenance >>]→[User Settings >>]→Enter the required
password→Select [Ok] and then access [User Settings] menu.
2. Select [Patient Demographics].
3. Set [Display Patient Name] to [Ye s ] or [No].
 [Ye s ]: the patient’s name display in the main screen.
 [No]: the patient’s name does not display in the main screen.
3.5.5 Adjusting Alarm Volume
1. Select [Main]→[General Setup>>].