Mindray VS-900 - Admitting a Patient from [Patient List]

4-4
2. Aim the scanner at the clinician barcode and press the scan button at the barcode
scanner. The clinician ID will populate the [Clinician ID] field in the [Patient
Demographics] menu.
3. Aim the scanner at the patient barcode and press the scan button on the barcode
scanner. The pop-up menu that opens depends on if [Patient Demographics] or
[ADT Database] is selected at the [Scanner Setup>>] menu.
4. Select [Ok] to admit the patient.
4.1.3 Admitting a Patient from [Patient List]
Admit a Patient from [Local Patient List].
1. Press [Patient List] QuickKey, and then [Local Patient List] screen displays.
2. Select the page key (for example ), and then use up or down arrow
beside the key to turn to another page, or select [Scroll] key and then use up or
down arrow beside the key to select the desired patient.
3. Select [Admit] to access [Patient Demographics] menu.
4. Select [Ok]. If necessary, you can modify patient information and then select [Ok].
In [Local Patient List], you also can:
 Select [Add New], and then [Patient Demographics] menu displays. Input
patient information and then select [Ok] to admit the patient.
 Select [Delete] to remove currently selected patient from the monitor.
 Select [Delete All] to remove all the patients from the monitor.
NOTE
 When a patient’s demographics is deleted, all his patient data in the monitor
will be deleted at the same time.
 You cannot delete the currently monitoring patient.
Admitting a Patient from [ADT Database]
When the monitor is connected to ADT database through Gateway, the monitor can
obtain patient information from ADT database.
1. Access the [ADT Database] screen by either way.
 Select [Patient List] QuickKey→[ADT Database] tab.
 Aim the 2D barcode scanner at the patient barcode. Refer to 4.1.2.2 With
Two-Dimension (2D) Barcode Scanner for scanner and monitor configuration.
2. Select [ADT Database], and then ADT database screen displays.
3. Search a patient.