Mindray VS-900 - Setting the Multicast Parameters; DIAP Communication Setup

14-6
2. Select [Import certificates >>] or [Delete certificates >>].
14.6 Setting the Multicast Parameters
Whether the equipment is presented by broadcast or multicast is defined before the
equipment leaves the factory. If [Multicast] is selected, you need to set the multicast
parameters.
To do so,
1 Select [Main]→[Maintenance>>]→[User Settings >>]→enter the required
password→Select [Ok]→[Network >>]→[Multicast Setup >>].
2. Set [Multicast Addr] and [TTL].
14.7 DIAP Communication Setup
1. Select [Main]→[Maintenance >>]→[User Settings >>]→Enter the required
password→Select [Ok] to access user settings menu.
2. Select [DIAP Communication>>] to access [DIAP Communication Setup] menu.
3. Set up the baud rate.
4. Select [Ok] to exit the menu.