2-3
Press this key to turn the monitor on.
If no parameter is being measured, press this key to enter Standby mode.
When the monitor is on, press and hold this key for above 2 seconds to turn the
monitor off.
An indicator is built in this switch. It turns on when the monitor is on and turns off
when the monitor is off.
(6) Battery indicator
On: indicates that the battery is installed and AC power is connected.
Off: indicates that the battery is not installed.
Flash: indicates that the monitor is powered by battery.
(7) Alarm Reset key
Press this key to disable the audio of present alarms.
Press and hold this key for more than 2 seconds to pause or restore alarms.
(8) NIBP Start/Stop key
Press to start or stop NIBP measurements.
(9) Admit patient key
Press this key to admit a new patient.
Press this key to return to the main screen.
(10) Knob
Rotate the knob clockwise or counterclockwise to move the cursor.
Press the knob to select one item, such as accessing a menu or confirming the
selection.
To Next Page
Loading...
