DICOM storage preset items are described as follows:
After you set the server (s) in DICOM Preset screen, the
name (s) will appear in the drop-down list, select the
name of the storage server.
Default is xxx-Storage, user-changeable.
Application Entity title, here, it should be consistent with
that of the storage server.
DICOM communication port, 104 is default. Here, the port
should be consistent with that of the storage server port.
Set the maximum retries (0-9). The default value is 3. If
the DICOM task sending to the server fails, the default
retry times is 3.
Refers to the amount of time after which the system will
stop trying to establish a connection to the service.
Transport Layer Security. Select whether to encrypt the
data during network transportation.
If SCP supports this function, select it.
Select the compression mode:
RLE (the image is not compressed),
JPEG (lossy compression for the image).
Select the JPEG compression ratio: lossless, low,
medium, and high.
The compression ratio is inversely proportional to the
image quality (reversed function).
If you choose the mixed or the gray, RLE/JPEG is
unavailable.
If you choose the mixed or gray setting, RLE/JPEG
compression mode will not be available.
The image uses 24 bits when sending the image from the
ultrasound device to the server; it depends on the image
when choosing the mix. The image uses 8 bits if the
image is captured in color mode or the image has a tint.
All images use 8 bits when captured in gray scale.
Select if the TRI data is sent together with other data.
To enable or disenable structured reporting sending.
To Next Page
Loading...
Need help?
General
