Mindray Zonare ZS3 Service Manual

ZS3 Service Manual
Page 95 of 295
MPPS setting items are described as follows:
Name
NOTE
Configure
new
service
Device
After you set the server (s) in DICOM Server Setting,
the name (s) will appear in the drop-down list, select
the name of the MPPS server.
Service Name
Default is server-MPPS, and it can be modified.
AE Title
Application Entity title. Here, it should be consistent
with that of the MPPS server.
Port
DICOM communication port, 104 by default. Here, the
port should be consistent with that of the MPPS
server.
Maximum
Retries
It starts retrying if it fails to send DICOM task to the
server. The retry entry times should be this value.
Interval
Time(Sec)
Reserved feature.
Timeout (Sec)
Value: 5-60s, in increments of 5, and 15 by default.
The connection is disabled if there is no message to
be sent in 15 seconds after the MPPS being sent.
Add
Add the DICOM service to the service list.

Mindray Zonare ZS3 Specifications

General

Brand	Mindray
Model	Zonare ZS3
Category	Diagnostic Equipment
Language	English