Click to cancel the parameter setting.
Select an item in the service list, change the
parameters in the above area, and click [Update] to
update the item in the service list.
Click to delete the selected service in the service list
Set the Worklist server as the default.
Select an item in the service list, click [Default] and
you can see “Y” in the Default column.
Click to verify if the two DICOM application entities are
normally connected.
Click to exit the screen.
NOTE:
Set the MPPS service as the default when using the MPPS.
STORAGE COMMITMENT SETTING
1. Select [Setup][DICOM][DICOM Service Setting][Storage] to enter the storage
page.
2. Select the device name, and type the information about the AE title, the port.
3. Click [Add]. The entry will be added in the service list.
To Next Page
Loading...
Need help?
General
