Minebea Intec PR 5220 Series User Manual

Note:
Some xBPI platforms have what is known as "specication blocks" for selecting
various modes of operation (single range, multiple range, etc.).
The following is required for the subsequent specication group selection:
- Note the model name of the scale.
- Refer to the operating instructions for the number of the corresponding
specication block.
Press [No] for exit from the menu without data change.
The parameters are listed as an overview in the following, see Chapter 7.13.5.1.
Note:
Only the parameters supported by the connected scale are displayed.
Press [No] for exit from the menu without data change.
4. Change the user ID and SBN address if necessary.
5. Press the softkey to exit the menu and to save the settings.
6. Select [Select group of specication] using the cursor and conrm.
7. Select and conrm the desired specication group.
8. Press the softkey to exit the menu and to save the settings.
A prompt window opens.
9. Press the [Yes] softkey to save the data.
The parameters are saved. Ticks indicate the progress.
10. Select [Conguration] using the cursor and conrm.
11. Select [Weighing parameters] with the cursor and conrm.
12. Press the softkey to exit the menu and to save the settings.
A prompt window opens.
13. Press the [Yes] softkey to save the data.
Transmitter Series PR 5220 7 Commissioning
Minebea Intec EN-100

Minebea Intec PR 5220 Series Specifications

General

Brand	Minebea Intec
Model	PR 5220 Series
Category	Transmitter
Language	English