PR 5220 - Message with device type PR 5220
- BIOS version
- Firmware version
- Automatic display test
- Weight display
Ext. meas. device error Error message: if no load cells are connected, see also
Chapter 16.1.
No values from scale Error message: if there is no communication with the xB-
PI scale (see also Chapter 16.1).
Error message: unable to read weight values from the
ADC (analog-digital converter); see also Chapter 16.1.
Scale not ready Error message: if no load cells or no scale is connected
(see also Chapter 16.3).
The weight display appears.
7.3 Switching o the device
The device is switched o/disconnected from power supply by pulling the plug.
7.4 Warm-up time
The device requires a warm-up time of 30 minutes before calibration.
7.5 Finding and connecting the device automatically in the network
If the DHCP server is active in the network, the connected device (default setting under
- [Network parameter]: "Use DHCP" is activated.) is automatically assigned an IP
address.
On the notebook/PC, the host names of the connected devices in the network are listed
under [Network].
Double-click the host name to open the device page in the WEB browser. The IP address
is displayed on the bottom right.
Transmitter Series PR 5220 7 Commissioning
Minebea Intec EN-60
To Next Page
Loading...
Need help?
General
