Minebea Intec PR 5220 Series - Selecting and Configuring RS-485 Interface

The calibration data for the gravity acceleration at the place of installation can be adapted
only in the instrument and protected against overwriting (see Chapter 7.1.3.1).
For connecting digital load cells (xBPI load cells), rmware version 2.10 or higher must be
installed.
The available interfaces are visible under -[Show HW-slots].
7.14.2 Selecting and conguring RS-485 interface
1. Select -[Serial ports parameter]- [xBPI-Port] and conrm.
The following window opens:
2. Select the desired interface and conrm.
3. Press the [Param] softkey.
The following window opens:
7 Commissioning Transmitter Series PR 5220
EN-111 Minebea Intec