Minebea Intec PR 5220 Series - Write Window (Input Area)

12.2.1 Write window (input area)
Data are transferred from the master to the slave(PR 5220) in this window.
Byte 0 Write data: MSB
Byte 1 Write data: MSB
Byte 2 Write data: MSB
Byte 3 Write data: LSB
Byte 4 Read_Value_Select
Byte 5 Write_Value_Select
Byte 6 Direct control bits
Byte 7 Direct control bits
The rst four bytes are used to write a data value.
The type of the register number of the data is written in byte 5.
In direct access, the bits in bytes 6 and 7 are independent of the write value data type.
The command is executed after a 0-1 transition of the corresponding bit.
Transmitter Series PR 5220 12 Fieldbus interface
Minebea Intec EN-190