Minebea Intec PR 5220 Series - Operating Parameters

7.15.2 Operating parameters
The operating parameters are set under this menu item.
Open the menu via -[Operating parameter].
The selected interface is displayed.
3. Press the [Param] softkey to set the parameters.
The following window opens:
4. Select [Baudrate] and conrm.
A selection window opens.
5. Select the desired transmission speed and conrm.
6. Select [Stopbits] and conrm.
A selection window opens.
7. Select the desired stopbit and conrm.
8. Press two times to exit the menu and save.
Transmitter Series PR 5220 7 Commissioning
Minebea Intec EN-130