Minebea Intec PR 5220 Series User Manual

[Ambient conditions]
This parameter is used to dene the ambient conditions of the scale.
Possible Selections: very stable condition, stable condition, unstable condition, very
unstable condition
[W&M]
Setting for legal-for-trade mode.
Note:
The transmitter of the series PR 5220 are not approved for calibration.
[Unbal. Check deviat.]
The plausibility check is activated when the average deviation is >0%. The average
deviation of the individual load cells is calculated.
Setting range: 0100%.
[Standstill time]
The parameters [Standstill time] and [Standstill range]are used to dene the stability of
the scale (stable balance).
The input for the parameter [Standstill time] is expressed in seconds.
Valid range: 0.002 s
If the tome is set to "0" there is no check. The standstill time must not be less than the
measuring time.
[Standstill range]
As long as the weight uctuations remain within this range, the device is determined to
be stable.
The input for the parameter [Standstill range] is expressed in "d."
Valid range: 0.0110.00 dc.
[Tare timeout]
Timeout for a tare/zeroset command that cannot be executed (e.g. due to mechanical
instability of the scale, incorrect lter setting, resolution too high, standstill condition too
strict).
The input is done as seconds.
Valid range: 0.0<2.5>25 s.
At 0.0 s taring is only carried out when the scale is already stable.
Transmitter Series PR 5220 7 Commissioning
Minebea Intec EN-122

Minebea Intec PR 5220 Series Specifications

General

Brand	Minebea Intec
Model	PR 5220 Series
Category	Transmitter
Language	English