23
EXIT/DUPLEX SWITCHING UNIT (OPTION)
If the copier is configured with an optional Sorter or Staple Sorter, or Duplex
Unit (installed in the Cabinet), the Exit/Duplex Switching Unit must be fitted
to the exit section of the copier.
Exit/Duplex Switching Plate
Drive Transmitting Gear
(coupled to a gear in the Exit
Section of the copier)
Main Control Board PWB-A outputs a signal to energize Exit/Duplex
Switching Solenoid SL61, which switches the position of the Exit/Duplex
Switching Plate. The Unit has 2nd Paper Exit Sensor2 PC30 built into it
which detects a sheet of paper being fed out of the Unit. (For more details of
switching control, see the Service Manual for "PAPER FEED CABINET.")
2nd Paper Exit Sensor2 PC30
Exit/Duplex Switching Plate
Exit/Duplex Switching Solenoid SL61
Paper Exit Roller/Rolls
M-78
To Next Page
Loading...
