Minolta EP1080 - Replacement of the Ozone Filter; Fusing Unit; Removal of the Fusing Unit

1. Press the Filter Cover Bracket in the direction of the
arrows and pull it off.
2. Remove the Filter and replace it with a new one.
(7) Replacement of the Ozone Filter
2-8. Fusing Unit
(1) Removal of the Fusing Unit
1. Remove one screw to remove the Ground Wire of the
Fusing Unit.
2. Unplug the Fusing Heater Lamp connector and
remove the cable from the clamp.
3. Unplug the Fusing Thermistor connector and remove
the cable from the two clamps.
1. Using a brush, whisk dust off the Lower Pre-Image
Transfer Guide Plate.
(6) Cleaning of the Lower Pre-Image Transfer Guide Plate
D-35