9. Remove the spring.
10. Remove two screws, one spring, and one cap to
remove the Cleaning Blade. Replace it with a new one.
When the Cleaning Blade has been replaced, apply
toner to the entire surface of the new Cleaning Blade.
NOTE
Replacement of the Cleaning Blade
Applying Toner to Cleaning Blade
Apply toner to the entire surface of the Cleaning Blade. (Do not forget to coat the surfaces on
both ends.)
Install the PC Drum.
Apply a thin coat of toner to the PC Drum.
Turn the PC Drum 1/2 turns backward, then turn it one complete turn forward.
8. Remove two screws to remove the Lid.
D-28
To Next Page
Loading...
