Minolta EP1080 - Cleaning of the Pre-Fusing Guide Plate; Removal of the Upper Fusing Roller

When reinstalling the Fusing Unit, install the Locking
Plate as illustrated on the left.
NOTE
1. Using a soft cloth dampened with alcohol, wipe clean
the Guide Plate.
(2) Cleaning of the Pre-Fusing Guide Plate
1. Remove two screws to remove the Fusing Unit Front
Cover.
2. Remove two screws to remove the Fusing Unit Upper
Cover.
(3) Removal of the Upper Fusing Roller
4. Remove one screw to remove the Fusing Unit Locking
Plate.
5. Turning it in the direction of the arrow, remove the
Fusing Unit.
3. Remove two screws to remove the Upper Paper
Separator Fingers Unit.
D-36