4. Remove two screws to remove the Fuse Holder Unit.
5. Remove the screw and clamp that secure the Lamp
harness at the front of the copier.
6. Remove the three clamps that secure the Lamp
harness at the rear of the copier and one clamp that
secures the Thermistor harness.
7. Remove one screw to remove the Mounting Bracket.
8. Slide out the Fusing Heater Lamp.
9. Remove two C-clips.
10. Remove one spur gear.
11. Remove two bushings.
12. Remove the Upper Fusing Roller.
D-37
To Next Page
Loading...
