Minolta EP1080 - Reduction

Reduction
1. After the leading edge registration in an enlargement
mode has been adjusted, make two single copies in a
reduction mode (50 %) and check for leading edge
registration on the second copy.
2. If the registration does not meet the requirement,
adjust the enlargement leading edge registration a
second time and ensure that leading edge registration
both in an enlargement and reduction mode meets the
requirement.
If dimension A on the copy is smaller than 8.5 mm,
increase the setting value in the enlargement mode.
If dimension A on the copy is greater than 11.5 mm,
decrease the setting value in the enlargement mode.
NOTE
D-60