(11) Adjustment of the Unexposed Areas/Edge Erase Lamp Position
◆Requirement
•
Edge erase width: Within 4 mm
◆Important
•
This adjustment must be made after the reference positions of the Manual Bypass Table and 1st
and 2nd Drawers have been adjusted.
1. With the Original Cover raised, place a sheet of A4 or
8-1/2" × 11 paper lengthwise on the Original Glass.
2. With the Original Cover raised, make a full size copy.
3. Check the erase width on the front edge and turn the
edge erase width adjusting screw as necessary to
obtain an erase width of less than 4 mm.
Loosening the screw will make the erase width
smaller.
Tightening the screw will make the erase width
greater.
NOTE
D-63
To Next Page
Loading...
