1139D047CA
AUTO
C
6. Press the Clear Key to clear the current setting value.
7. With the old setting value used as reference, enter the
new setting value using the appropriate Multi-Copy
Keys.
1139D019CA
Start
Panel reset
8. Press the Start Key to validate the setting.
9. Press the Panel Reset Key twice (or turn OFF the
Power Switch) to return the copier back to the normal
mode.
10. Make two single copies and check for leading edge
erase width on the second copy. (If it does not meet
the requirement, perform steps 3 through 9 again.)
If the erase width on the copy is less than 0.5 mm,
increase the setting value.
If the erase width on the copy exceeds 6.5 mm,
decrease the setting value.
NOTE
D-62
To Next Page
Loading...
