27
ORIGINAL COVER ANGLE DETECTION
Original Cover Detecting Sensor PC111 detects the angle of the Original
Cover as it is raised. The following control is provided.
Original Cover raised to an angle of 15° or more:
The size of the original is read by the Original Size Detecting Sensors.
Original Cover raised to an angle of less than 15°:
When PC111 is activated, the original size data is latched and Original
Size Detecting Board UN2 transmits the size data to PWB-A. As soon as
Size Reset Switch S108 is turned ON, the size data is validated and the
paper size is shown on the control panel.
The paper size selected is reset when S108 is turned OFF.
*
The Original Cover Angle Detecting System is available only on copiers for
Japan, ROC, South Africa, Singapore, Malaysia, Indonesia, Saudi Arabia,
Curacao, Australia, and New Zealand. The copiers for any other areas are
not provided with the Original Size Detecting Sensors and, S108 is used for
detection of raising and lowering of an Automatic/Duplexing Document
Feeder (option).
Original Cover Detecting
Sensor PC111
Size Reset
Switch S108
Magnet
1139C30MAA
M-86
To Next Page
Loading...
