10. Paper Size Input Mode
•
This mode allows the Tech. Rep. to enter the size (length and width in mm) of the paper
loaded in the 2nd Drawer of the copier and the Drawers/Trays of PF-201 or PF-101 (for Inch
Areas).
Types of Paper Size Data and Input Order
Order Description Order Description
1 Copier 2nd Drawer length 4 PF-201 3rd Drawer width
2 Copier 2nd Drawer width 5 PF-201 4th Drawer length
3 PF-201 3rd Drawer length 6 PF-201 4th Drawer width
NOTE: For PF-101 (for Inch Areas), use the PF-201 3rd Drawer for entry of the size data.
Data Entry Procedure
No. Procedure
Magnification
Ratio
Indicator
Multi-Copy
Display
Description
1
With the copier in the state
ready to enter a particular
Tech. Rep. Mode, press "9" to
set the copier into the Paper
Size Input Mode.
XXX 2F
When the copier is set into the
mode, the Magnification Ratio
Indicator shows the previous
length setting for the 2nd
Drawer of the copier.
2
Press the Clear Key to clear
the previous setting.
XXX 2F
The previous length setting is
cleared.
3
Using the Multi-Copy Keys,
enter the length data.
XXX 2F
The length data for the 2nd
Drawer is entered.
4
Press the Paper Select Key.
XXX 2C
The Magnification Ratio
Indicator shows the previous
width setting for the 2nd
Drawer of the copier.
5
Press the Clear Key.
XXX 2C
The previous width setting is
cleared.
6
Using the Multi-Copy Keys,
enter the width data.
XXX 2C
The width data for the 2nd
Drawer is entered.
* Enter the size data for PF-201 or PF-101 using the same procedure.
* Entry of size data for the 1st Drawer of the copier is not possible.
S-22
To Next Page
Loading...
