Setting Procedure
(1) With the copier in the state ready to enter a particular Tech. Rep. Mode, press "0" to set the
copier into the Display Mode.
(2) Press the Multi-Copy Key that corresponds to the desired display type.
(3) Press the Clear Key. This makes the copier ready to accept entry of a new display type.
11. Display Mode
•
This mode permits checking of the time it takes the copier to complete different functions. (This
should only be used at the factory.)
Types of Displays
Multi-Copy
Key
Description
Magnification Ratio
Indicator (Time)
Multi-Copy Display
(Code)
0 Warm-up time (×100 ms) XXX d0
1 First copy time (×100 ms) XXX d1
2 Multiple copy time (×100 ms) XXX d2
6 Display test mode All Indicators blink. d6
S-24
To Next Page
Loading...
