6. Unhook the spring to remove the shorter length of the
Cable.
7. Move the 2nd/3rd Mirrors Carriage towards the
Scanner Drive Gear so that the Cable slacks off and
then remove the longer length of the Cable.
8. Remove three screws to remove the Scanner Motor
Mounting Bracket.
9. Snap off one E-ring and remove the Scanner Drive
Gear.
10. Remove two screws to remove the Pulley.
11. Remove the Cable.
4. Align the Scanner with the rectangular hole in the
upper copier frame and remove the screw from the
Scanner Fixing Bracket.
5. Remove the Fixing Bracket.
D-22
To Next Page
Loading...
