4. Fit the Scanner Drive Gear onto the Scanner Motor
Mounting Bracket using one E-ring.
5. Secure the Scanner Motor Mounting Bracket to the
frame using three screws.
6. Insert a wrench into the holes in the Scanner Drive
Gear and the frame to position the Gear.
7. Wind the longer length of the Cable around Pulleys C
and B and then secure it to the frame.
8. Wind the shorter length of the Cable around Pulleys A
and B.
Wind the longer length of the Cable around the lower
groove in Pulley B (of the two grooves). Position the
terminal of the Cable as illustrated on the left.
NOTE
Wind the shorter length of the Cable around the
upper groove in Pulley B (two grooves).
NOTE
D-24
To Next Page
Loading...
