(3) Adjustment of the Optimum Exposure Setting in the Auto Mode
◆Important
•
This adjustment must be made after the optimum exposure setting in the Manual Mode has
been adjusted.
1. Place about five sheets of A3 or 11" × 17" paper on
the Original Glass and lower the Original Cover.
1139D017CA
5
1
0
Stop
2. On the control panel, press the Stop Key, Multi-Copy
Key "0," Stop Key, and Multi-Copy Key "1," in that
order, to set the copier into a state ready to enter a
particular Tech. Rep. Mode.
3. Press Multi-Copy Keys "1" and "5" to set the copier
into the F5 Test Mode. (At this time, the Multi-Copy
Display shows "F5.")
1139D019CA
Start
Panel reset
4. Press the Start Key to let the copier make the
adjustment.
5. After the adjustment has been made, press the Panel
Reset Key twice (or turn OFF the Power Switch) to
return the copier back into the normal mode.
Pressing the Start Key lets the copier make the adjustment of optimum exposure setting.
During the adjustment, the Start Key is lit up orange. It turns to green as soon as the
adjustment is completed. (It takes about 5 sec. to make the adjustment.) The Full Size Key can
be used to alternately display on the Magnification Ratio Indicator either the adjusting value (AE
Sensor memory level) or the voltage value (AE Sensor output).
NOTE
D-51
To Next Page
Loading...
