Minolta EP1080 - Page 241

◆ Copier Take-Up Misfeed Clearing Procedure
Symptom Step Check Item Result Action
•
Paper is not taken
up at all. 1
Is the paper being used up
to product specifications? NO
Instruct the user to use the
paper that is up to product
specifications.
•
Paper is
stationary before
the Paper
Take-Up Sensor.
2
Is the paper curled, waved,
or damp? YES
Change the paper.
Instruct the user in how to
store the paper.
3
Are the Separator Fingers
on both sides of the Drawer
in position?
NO
Instruct the user to load the
paper so that it rests under
the Fingers.
4
Are the Separator Fingers
deformed?
YES
Replace the Fingers.
5
Is the Trailing Edge Stop or
Edge Guide in good
position?
NO
Instruct the user in how to
position the Edge Stop or
Guide.
6
Are the Paper Lifting
Springs positioned
correctly?
NO
Change the position of the
Spring or add one as
necessary.
7
Are the Paper Take-Up
Rolls deformed, worn, or
dirty with paper dust?
YES
Clean or replace the Paper
Take-Up Rolls.
8
Is a signal being output
from PWB-A to the Paper
Take-Up Solenoid?
YES
Adjust the Solenoid stroke.
Check the Solenoid.
*
Does the voltage across
PJ16A-1 (1st Drawer) or
PJ17A-1 (2nd Drawer) on
PWB-A and GND change
from DC24V to DC0V
when the Start Key is
pressed?
NO
Replace PWB-A.
9
Is the Clutch Spring
deformed or worn?
YES
Replace the Clutch Spring.
Continued on next page
T-9