SERVICE NEEDED
Parameters corrupt
Note: This display
message is only shown in
English.
The handset is defective. Send the handset for service.
SERVICE NEEDED
Invalid IPDI
Note: This display
message is only shown in
English.
Easy replacement procedure not
followed correctly or failure during
easy replacement procedure.
Send the handset for service.
Enter PIN code The handset’s lock is activated. Enter the required PIN code. If
PIN code lost enter new via
WinPDM or do a factory reset via
WinPDM.
Battery low, charge now The battery level is low. Charge or replace the battery.
Phonebook is not
available at the moment.
The phonebook does not respond,
not available at the moment.
Try again later or if fault persists
do a factory reset via admin menu
or WinPDM.
Voicemail number not
defined
There is no Voicemail number
defined in the handset.
Define a Voicemail number via
WinPDM.
Could not encrypt
connection
The parameter "Encryption
Required" is enabled in the handset
in combination with;
1) Unencrypted base station(s);
and/or,
1) Disable the "Encryption
Required" parameter in handset;
and/or,
2) Unsupported base station(s). 2) Enable the encryption in the
base station(s); and/or,
3) Use supported base station(s).
Ask your supplier.
Not allowed 1) The user cannot login to the
handset with the shared phone
functionality enabled, due to another
handset currently using the same
extension (User).
1) Logout from the handset that
uses the same extension.
2) The user cannot logout from the
handset with the shared phone
functionality enabled, due to
incorrect password (AC code).
2) Enter #11*<AC code># on the
keypad and press the off-hook
key to logout from the shared
phone.
To Next Page
Loading...
