Mitel 5614 DECT Phone User Manual for MiVB
SWITCH THE HANDSET ON AND OFF
SWITCH ON THE HANDSET
Press and hold . When pressing , the handset vibrates and the display lights up.
SWITCH OFF THE HANDSET
Prerequisite: The handset is in idle mode:
1. Press and hold .
2. A dialog window "Switch off?" is displayed. Confirm by pressing "Yes".
LOG A SHARED PHONE ON AND OFF
The feature shared phone allows more than one user to use a handset. When a handset is
configured to be a shared phone, it can be used by any shared phone user in the system. The
message and call lists are deleted when a user logs off a handset.
Log on a Handset
Prerequisite, the handset is switched on. See Switch the Handset On and Off for more information.
1. A dialog window "Login?" is displayed. Press the soft key "Yes".
2. Enter User ID and password.
3. Press "Login"
Log off a Handset
1. Press and hold .
2. A dialog window "Logout?" appears. Press the soft key "Yes".
Tip: While in a menu, press to return to idle mode. If the handset is a shared phone, it must
first be logged out to be able to switch off the handset. See Log a Shared Phone On and Off. A
user can be prevented from switching off the handset by enabling the parameter Prevent switch
off in WinPDM.
Note: If a handset restriction is enabled, it may not be possible to switch off the handset. Refer
to the Configuration Manual for the handset; see Related Documents on page 127.
Note: Shared phone is applicable for IP-DECT systems only. For more information, refer to the
Configuration Manual for the handset; see Related Documents on page 127.
Note: If configured in the WinPDM/Device Manager, an emergency call can be made from a
handset that is logged off.
Note: The user will be automatically logged out from a previously used handset.
To Next Page
Loading...
