Mitel 5614 DECT Phone User Manual for MiVB
MAINTENANCE
MAINTENANCE OF BATTERIES
BATTERY WARNINGS
During a call, only the corresponding battery warning signal notifies the user. The warning signal
cannot be silenced during a call. When not in call, the warning signal can be silenced by
pressing or .
CHARGE THE BATTERY
Place the handset in the desktop charger or in the rack charger. An animated battery icon is
also shown in the display indicating charging by starting with its current charge and ending with
the full charge. A filled battery icon indicates a fully charged battery.
CHARGE SPARE BATTERIES
Spear batteries can be charged with a separate battery pack charger. It can charge six batteries
at the same time.
REPLACE THE BATTERY
If the standby time for the handset becomes too low, the battery should be replaced by a new
one. Contact the system administrator or handset supplier for information about new batteries.
Attach the battery as described in the illustration below. The battery is easy to replace. It is
attached inside the battery lid and is connected to the handset in such a way that no
misalignment of the contact is possible.
The "Low battery" icon is displayed when the battery has 10% or less remaining
capacity left. In addition; a warning signal sounds every minute and the dialog
window "Battery low. Charge now." appears.
The "Empty battery" icon is flashing when the battery has 5% or less remaining
capacity left. In addition; a warning signal sounds every second and the dialog
window "Battery empty. Shutting down." appears.
Note: Only use the prescribed chargers for charging.
To Next Page
Loading...
