7. When headset is found, press "Pair".
8. If needed, enter PIN code, see user manual for the Bluetooth headset. Press "OK".
The dialog Successful pairing appears if the pairing process was successful. The Bluetooth
headset is also connected indicated by a colored square in front of the headset.
Tip: The headset button can be configured with a specific function, such as post-dial, dial last
called number, or dial a predefined number. For more information, refer to the Configuration
Manual for the handset; see Related Documents on page 127.
HEADSET
In order to achieve optimal audio quality with the different headset types, it is recommended to
select the corresponding headset profile.
The default setting is microphone on a boom, that is, the audio is optimized for using a headset
with microphone on a boom. The headset profile can be changed in the menu by do as follows:
1. Select "Headset".
2. Select the corresponding headset profile from list, that is, "Mic on boom", "Mic on cable",
"Hearing protection", or "Customized headset profile" (only visible if the headset profile has
been configured in the WinPDM/Device Manager).
3. Press "Select".
SYSTEM
The handset can subscribe up to eight different systems.
Change System
Select “Automatic” or a specific system. If the handset is set to “Automatic” it selects a system
according to the priority list, see Priority on page 77.
Subscribe Handset in IP-DECT System using Easy Registration
A handset can subscribe to an IP-DECT system automatically if the following are fulfilled:
• The IP-DECT system is configured for Easy Registration, refer to the corresponding Instal-
lation and Operation manual for the IP-DECT system.
• The handset’s IPEI is registered in the IP-DECT system, refer to the corresponding Instal-
lation and Operation manual for the IP-DECT system.
• The handset is not subscribed to any systems.
1. If needed, switch off the handset by pressing .
2. Switch on the handset by pressing .
3. Select language to be used or press "Cancel". If Cancel is pressed, the default language
English is used.
4. The handset starts to search for IP-DECT systems. When a system is found the handset
subscribes to it.
To Next Page
Loading...
